REVERE AND GE CHIMING CLOCKS

Welcome Page  Revere History  Repair Gallery  Westminster Repair Service  ID Your Revere/GE  Date Your Revere/GE
Revere Restoration Video  Revere History Video  Adjust Your Chimes Video  Remove and Replace Your Movement Video


How to Remove and Replace the
Movement from your Revere or GE Clock

This video shows how to remove a typical Revere or GE movement from it's case. Replacing it is shown below.

This video shows how to replace a typical Revere or GE movement in it's case.

This shows the rotor/coil assembly and a diagram of how it is attached to the movement. If you are removing the rotor follow these steps Loosen the set screw on the rotor gear. Remove the two screws holding the coil/rotor assemble to the movement. Slide the coil and rotor back, removing the gear on the rotor shaft so it will pass through the opening. Remove the rotor from the coil arms. Reassemble in reverse order.

click to enlarge

Silverdollar Clocks
Not Meant for Everybody
Just You





PO BOX 1056 * NEW SMYRNA BEACH * FLORIDA 32170
* 386 427-7021 *
info@SilverdollarProductions.net
© 2000-2012 Silverdollar Productions, Inc. All rights reserved.
This page is printed on 100% recycled paper